HiLetgo 4pcs L298N Motor Driver Controller Board Module Stepper Motor DC Dual H-Bridge for Arduino Smart Car Power UNO MEGA...

Amazon.com Price: $11.49 (as of 12/17/2022 07:42 PST- Details)

Make sure this fits by entering your model number.
L298N as main driver chip makes strong driving ability/small heating/strong anti-interference/low calorific value
Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability

Description

Specification:
Chip: ST L298N dual H-bridge Driving force chip
Logic voltage: 5V
Logic current 0mA-36mA
Storage Temperature: -20 ¡æ to +135 ¡æ
Operating mode: H-bridge Driving force (dual)
Drive voltage: 5V-35V
Drive current: 2A (MAX single bridge)
Maximum power: 25W
Driving force Board Size:55mm*60mm*30mm
Driving force Board Weight:33g
Dimensions: 43x43x27mm

Note:
.General Application: When your Driving force is 7V-12V, you’ll be able to enable the on-board 5V logic supply. When the usage of the on-board 5V power supply, the + 5V power supply within the interface does now not input voltage, but it will probably draw 5V voltage for external use.
.Unconventional application of high-voltage drive: When the driving voltage is higher than 12V, lower than or equal to 24V, as an example, to drive a motor with rated voltage of 18V, the jumper cap with 5V output enabled on-board voltage should be pulled out after which outdoor the 5V output port Connect 5V voltage to L298N internal logic voltage supply.

Package Included:
4* L298N Motor Driving force controller Board Module

There are two how you can turn the system back on:
1. flip the ability switch at the back of the pc and look ahead to the ability supply cap to discharge because the relay will reset without power.
2.after popping the hood and examining for faults, press the button at the relay.There’s a red LED in this for power and a green LED to suggest the relay is activated, so you’ll be able to be pretty sure what state that is in .
Any time you are attempting to hot wire an ATX power supply and you want a toggle serve as but even so the switch within the back, just needs power from pin 9, the relay attached to pin 16 after which in fact connections back to ground pin(s).

Be sure that this fits by entering your model number.
L298N as main Driving force chip makes strong driving ability/small heating/strong anti-interference/low calorific value
Use large-capacity filter out capacitors and diode with freewheeling protection serve as, increasing reliability
Dual-channel H-bridge Driving force working mode creates higher working efficiency
To steer clear of damage the voltage stabilizing chip, please use an external 5V logic supply when the usage of more than 12V driving voltage
Large capacity filter out capacitance, afterflow protection diode, more stable and reliable

Additional information

Brand

Manufacturer