This Motive force uses Infineon chips BTS7960 composed of Prime-power drive full H-bridge Motive force module with thermal over-current coverage. Double BTS7960 H-bridge Motive force circuit, with a robust drive and braking, effectively isolating the microcontroller and motor Motive force! Prime-current 43A.
Input voltage: 6V-27V
Maximum current: 43A
Input level: 3.3-5V
Control manner: PWM or level
Duty cycle: zero-one hundred percent
1.RPWM: forward level or PWM signal input, active high
2.LPWM: Reverse level or PWM signal input, active high
3.R_EN: forward drive permit input, Prime-level permit, low level off
4.L_EN: Reverse drive permit input, Prime-level permit, low level off
5.R_IS: forward drive current alarm output
6.L_IS: Reverse drive current alarm output
7.VCC: +five V power output, 5V power provide reference to the microcontroller
8.GND: signal commonplace low end
1BTS7960 43A Prime Power Motor Motive force Module/ Sensible Automobile Motive force Module
Be certain that this fits by coming into your model number.
5V isolate with MCU, and effectively offer protection to MCU; 5V power indicator on board.
Voltage indication of motor Motive force output finish; can solder warmth sink.
Simply want 4 lines from MCU to Motive force module (GND. 5V. PWM1. PWM2); isolation chip 5 V power provide (can percentage with MCU 5 V).
Ready to reverse the motor forward, two PWM input frequency as much as 25kHZ; two warmth waft passing thru an error signal output.
Isolated chip 5V power provide (will also be shared with the MCU 5V), too can use the on-board 5V provide; the provision voltage 5.5V to 27V.